TREMproof PUMA Decorative Flashing System is a quick-cure, liquid-applied system based on PUMA technology. Components of the system can be initiated to cure within minutes, even in temperatures below freezing, and has tenacious adhesion to concrete and metal.
|Tremco PUMA BC LM SDS|
|Tremco PUMA BC LM SDS (CAN)|
|Tremco PUMA BC SDS|
|Tremco PUMA BC SDS (CAN)|
|Tremco PUMA BC R SDS|
|Tremco PUMA BC R SDS (CAN)|
|Tremco PUMA BC T SDS|
|Tremco PUMA BC T SDS (CAN)|
|Tremco PUMA Cleaner SDS|
|Tremco PUMA Cleaner SDS (CAN)|
|Tremco PUMA Filler Powder SDS|
|Tremco PUMA Filler Powder SDS (CAN)|
|Tremco PUMA Flashing SDS|
|Tremco PUMA Flashing SDS (CAN)|
|Tremco PUMA Initiator SDS|
|Tremco PUMA Initiator SDS (CAN)|
|Tremco PUMA Primer SDS|
|Tremco PUMA Primer SDS (CAN)|
|Tremco PUMA TC Decorative SDS|
|Tremco PUMA TC Decorative SDS (CAN)|
|Tremco PUMA WC SDS|
|Tremco PUMA WC SDS (CAN)|
PUMA technology can be used in both traffic coating (Vulkem EWS) and below grade (TREMproof PUMA) applications.
Concrete shall be water cured and attain a 4000 PSI minimum compressive strength for vehicular or heavy duty traffic and 3000 PSI minimum for pedestrian, buried or non-traffic bearing systems. All concrete shall be shotblast to a ICRI CSP #3-#4 finish. Moisture content in the concrete must be lower than 6% as measured using a Tramex CME 4 Moisture Meter. Depending on concrete construction and job site location, additional concrete testing may be required. Please contact your local Tremco Sales or Technical Representative.
Each layer of all PUMA technology systems cure in 30-45 minutes and the next coat can be applied at that time. In fact, they can be opened up to traffic one hour after installation is complete. Please contact your local Tremco Sales or Technical Representative when choosing the appropriate system for your application.